How To Repair Nail Holes In Concrete Floor

Removing carpet from a concrete floor is a fourth dimension consuming process. Carpet withal requires tack strips, and tack strips ordinarily nail into the sub-floor.

Removing tack strips from a physical floor leaves backside small nail holes along the outside perimeter of the physical floor. A composite cement patch compound does a expert job of roofing up carpet tack holes on concrete floor. However, training of the holes and the surrounding concrete is necessary to ensure a stiff patch. The Physical Colorist has become a master of hiding these fiddling holes.

This calendar week I will discuss how to hide the holes with a concrete based hole patch.

Brush the holes with a strong wire brush to remove any loose pieces of concrete. Sometimes loose fries remain unseen until you castor over them. This helps to ensure you patch the entire area of the hole.

Remove the droppings and physical grit from the hole with a vacuum. Loose particles prevent the patch from adhering to the physical.

iii

Fill up a saucepan with clean water. Dip a rag into the water and wring it out well. Dampen the holes with the rag. Concrete draws in moisture. Dampening the concrete before applying the patch helps prevent the concrete from drawing moisture from the patch before it fully cures. Exercise not moisten then much that there is continuing h2o in the lesser of the holes.

Mix the blended cement patch in a bucket according to the package directions. The concrete patch should have a thick, muddy consistency.

Scoop the patch mixture with the corner of a trowel and printing information technology into the nail holes.

Agree the trowel at an angle once you fill the holes and swipe over the patch and concrete.

This smooths the patch to the surface level of the concrete floor.

If you are covering holes across a hallway or just want a boarder y'all can tape off a edge.

The holes must always be filled individually as trying to float out a whole edge at in one case will exit pocket-size indention's where the holes were. Make full the holes first then float out a boarder.

Remove your record before the cement dries. This will brand a sharp edge.